Some Processes Employed at Clear Carbon and Components

Clear Carbon and Components uses many processes and combinations of processes to manufacture parts. Here are a few of the ones we use most often.

Contoured Composite Tubing (CCT)
This new process can create complex 3D tubular structures from composites.
Rail Termination with out-turning flange15 inch grab rails Part made using Contoured Composite Tubing processPart made using Contoured Composite Tubing process
Contoured Pultrusion Process (CPP)
CPP is a cutting edge technology that can created solid and hollow composite shapes, such as springs.
Carbon SprngThick Carbon SpringSmall Diameter Carbon Spring

Wet lay-up epoxy vacuum molding
Wet lay-up epoxy carbon vacuum molding Wet lay-up epoxy carbon vacuum molding in progress

Vacuum assist resin transfer molding (VARTM)

Electronics enclosure made with VARTM processWrapping fiberglass preform to make VARTM partVARTM part being infused with resinCommunications buoy made with VARTM process

Pre-preg compression molding
Pre-preg compression molding

Pre-preg epoxy carbon vacuum molding
Pre-preg epoxy carbon vacuum molding

Wet-lam compression molding
Wet-lam compression molding